Hook up two way light switch

Last Updated: March 29, References. To create this article, volunteer authors worked to edit and improve it over time. There are 12 references cited in this article, which can be found at the bottom of the page. This article has been viewed , times.

We are going to refer to this light control circuit as a two way switching circuit. Each terminal on a SPDT switch has a name. The input terminal is called Common. The output terminals are called Normally-Open and Normally-Closed.

Two, 2-wire cables C3 and C4 run between the fixtures, and a 3-wire cable C2 runs from the second fixture F2 to the second 3 way switch SW2. The hot source is connected to the common terminal of SW1. The neutral is spliced to the white wire feeding the first fixture, via cable C1,where it is spliced to the neutral of both lights. You must be logged in to post a comment. Tags 2 lights 2 way switch 3 way light switch 3 way switch 4 way light switch 4 way switch crossover switch Four way switch how to wire a 2 way switch how to wire a light switch power feed via light Power feed via switch switches three way light switch Three way switch travelers two lights two way two way light switch two way switch.

Wiring electrical outlets properly called receptacles and switches involve many of the same basic techniques. Making safe, long-lasting connections requires properly preparing the circuit wires that will connect to the device and secure each wire to the correct terminal. The standard best practice for connecting circuit wires to a switch or receptacle is to use the screw terminals, which are typically located on the sides of the device body. To make a safe, secure connection using screw terminals :. When an outlet receptacle is located in the middle of a circuit run—with other receptacles "upstream" and additional receptacles "downstream"—there are two ways to wire the receptacle.